Black Friday
Ponude mjeseca  -  Kliknite ovdje
×
Menu

Alpinist U-Bow

(10)
Požurite! Samo 2 na zalihi
1 par
Broj
1 par
2 pari
Limited quantity available
Broj
1 par
2 pari
3 pari
4 pari
Limited quantity available
Broj
1 par
2 pari
3 pari
4 pari
5 pari
6 pari
7 pari
8 pari
9 pari
10+
Dodaj u košaricu
  Spremiti za kasnije
Besplatna dostava od 79 €
Dostava 5 radnih dana
365 dana za povrat robe

Opis

Ispričavamo se, ali ovaj opis je trenutno dostupan samo na engleskom jeziku.
Prikaži opis na engleskom

Specifikacije modela

ModelTežina
Soft32g
Medium35g
Hard40g

Specifikacije

Najbolja uporaba:
Touring
Pokaži sve

recenzije   (10)

Provjereni kupac
"Quick delivery from the US to Canada and exactly as ordered. Flawless shopping experience! My tip to install, use a fairly big set of those quick adjust pipe wrench that opens to 2” gap or so. Just press them into position and use them to get the old ones half way out. Easy peezy."
Flavelle Scott (Mount Currie) 27/01/21
Provjereni kupac
"The Marker U springs arrived faster than expected, and are exactly as advertised."
Kenneth Linden (Irvine) 19/01/21
Provjereni kupac
"Completely agree with Karol below. Nightmare to install. Had to file the inner edge a bit to get them on, after various failed attempts started to chew up the plastic/carbon body of the binding. The cut ends of the springs are pretty unrefined and could do with a bit of filing before they leave the factory. Once on, they work fine, I'm sure, and I got a swift and sensible reply from Skatepro when I asked for advice, so overall a positive experience. Would certainly use this retailer again."
Archie Gillies (Aberdeen) 12/11/20
Provjereni kupac
"Have not had a chance to test them, not enough snow yet, but have no reason to believe they would not work. Got them to replace the "hard" DIN 12 bows that came with my bindings. They certainly were a bitch to install though. Not like the manufacturer describes it, just remove the small screw and slide it out/slide it in. The prongs are not quite parallel but rather convergent a bit. At the end I managed to spread them a little by forcing a suitable size of a socket wrench in between of them."
Karol S. (Northport) 28/10/19
Prikaži sve 10 recenzije
SkatePro